Important Safety Instructions - Weller Pyropen WP 60 Mode D'emploi

Important safety instructions

Please read these Operating Instructions and the attached safety information carefully prior to
initial operation of the soldering iron. Failure to observe the safety regulations results in a risk
to life and limb. The manufacturer shall not be liable for damage
resulting from misuse of the machine or unauthorised alterations.
1. Do not use any device which is leaky (gas odour) or is damaged or not in perfect
working order.
2. Never try to detect leaks with a naked flame. Use only soapy water.
3. If damage is found, the device must not be used and the tank must not be refilled.
4. Do not fill gas or store near open flame, heater, furnace or combustible materials.
5. Use only non-aromatic butane gas as recommended by the manufacturer.
6. Be sure to put switch down after use.
7. Operate the device only in well-ventilated areas and well away from ignition sources
or flammable objects.
8. Avoid dropping or causing a hard shock.
9. Do not use iron holder designed for the electrical iron. This may cause burning of tool
body.
10. Do not store under direct sunlight or anywhere that will exceed 50°C or 122°F.
This will cause fire / explosion as gas pressure become high.
11. Do not store near windshield, in trunk of car.
12. Keep out of reach of infants.
13. Keep hands and combustibles clear out of exhaust opening and tip housing to avoid
burns or fire. Keep well away from face and clothing when igniting.
14. Do not immerse in water.
15. Do not try to disassemble or misuse or alter or tamper.
16. Do not drill holes in or open the device.
17. Cool down before putting protective cap on.
18. Repairs are only to be performed by authorised specialist personnel.
19. Refer all repairs to authorised specialist personnel or the manufacturer.
20. Before taking soldering tools on board aircraft, always check the applicable
transport regulations specified by the airline company.
How to use a soldering iron and hot blow
Exhaust opening
Ignition hole
Knurled nut
Gas open lever
Gas control
lever
17