Safety Instructions; Scope Of Supply - Weller WRS 3000 Manuel D'utilisation

Switching off the pump over-run
Switch off the unit. Press the „up" and „down" buttons when switching the unit back on,
until the self-test is finished. A „-0-" will appear on the display. Release the buttons.
Switching on the pump over-run
Switch off the unit. Press the „up" and „down" buttons when switching the unit back on,
until the self-test is finished. A „-1-" will appear on the display. Release the buttons.
For operation with the soldering bit:
On first heat-up, treat the selectively tinnable solder tip with solder. This will remove any
layers of storage-related oxidation coatings on the solder tip and any impurities in it. During
breaks in soldering and before the solder bit is parked, always ensure that the solder tip is
well tinned. Do not use any flux agents that are too aggressive.
Caution: Never operate the soldering bit without a tip, otherwise the heating
elements and temperature sensors will be damaged.
General information:
On the unit's backplane there are two footswitch connections; footswitch 1 is allocated to
channel 1, footswitch 3 to channel 3. The function of the footswitch corresponds to the
function of the finger-operated switch for the inserted tool. Soldering units have been set for
a medium-sized solder tip or nozzle. Deviations may arise if tips are changed or if other
forms of tip are employed.

4. Safety instructions

No liability is undertaken by the manufacturer for applications other than those in the operating
instructions, nor for any unilaterally applied modifications.
These operating instructions and the warning notes contained therein must be read carefully
and placed in a clearly visible position near the solder unit. Failure to adhere to warning
notices can cause accidents and injury or damage to health.
The WELLER WRS 3000 soldering/desoldering station complies with the EC statement of
WRS3000 12
compliance in accordance with the underlying safety requirements of guideline 89/336/EEC,
73/23/EEC.
5. Alternate / optional tools
WSP 80 Iron 80 W
WSP 80 AP Iron with stand
EC 1201A 42 W Iron std.
EC 1201AP Iron with stand
EC1302A 20W Iron mini
EC1302AP Iron with stand
EC1503A 42 W iron Hi-Output
EC1503AP Iron with stand
52711599 Hot air pencil
HAP 1 Pencil with stand
MPR 30 30 W Peritronic (Offset) Iron
KH 25P Stand for MPR 30
DS 1203A Desoldering Iron
DS 1203AP Desoldering Iron with stand
FS 1 Foot switch
WHP S Pre-heat plate
WST 20 Thermal stripper without blades
DSV80 Desoldering Iron, 80 W, in-line
DSV80Set Desoldering Iron, 80 W, in-line, w / AKV stand
DS80 Desoldering Iron, 80 W, pencil style
AKV Iron stand, DSV80
AK20 Iron stand, DS80
WTA50 SMD Thermal tweezer, 50W
WTA50Set SMD Thermal tweeer, w / AK51 support, 50W
AK51 Support for WTA50, Thermal tweezer

6. Scope of supply

5 33 026 99 WRS 3000 Soldering/desoldering station
Mains cable
Operating Instructions
21.03.2003, 8:40 Uhr
12