How To Mount - Weller PYROPEN Piezo Manuel D'utilisation

PK Elektronik Vertriebs GmbH, E-Mail: info@pkelektronik.com, Internet: www.pkelektronik.com
HOW TO CHANGE THE BURNER EJECTOR
1.
Loosen knurled nut to remove tip and tip
housing.
3.
Insert the accessory bar into the ejector hole
and hold. Then, with the accessory wrench,
turn the burner unit counter-clockwise. (Be
careful as the white portion is fragile ceramic).

HOW TO MOUNT

1.
Mount new ejector and tighten with the
accessory bar.
3.
Use the accessory wrench to tighten.
Place the lead wire and ignition plug in a
straight line.
HOW TO USE THE IRON HOLDER
Put accessory on any box edge as illustrated (one larger nail of holder comes outside of
box and two nails inside).
Wrong
2.
Hold the lead wire and pull toward side
slowly. The lead wire will then come
away from the insulation tube.
4.
2.
Insert the accessory bar into the ejector
hole. Mount the burner unit to the ejector
and turn clockwise.
4.
Insert the lead wire into the insulation
tube. Push ignition button to confirm
sparking.
Correct
16