125987721_EN.qxp
2007-07-02
• Push it until it clicks and turn the yellow
stop downwards to firmly lock it.
• Close the small door and press the
START/PAUSE
the programme to continue.
The reservoir must be re-inserted
correctly.
If this is not done the pilot light
during next drying and the programme stops,
leaving the laundry damp. The buzzer will sound
for 1 minute.
After emptying and inserting the reservoir the
START/PAUSE
again to allow the programme to continue.
Handy tip: The condensed water may be used in
a steam iron or to top up a battery, etc. In this
case it must be filtered (e.g. through a coffee
filter).
16
09:37
Page 16
button again to allow
comes on
button has to be depressed
Cleaning the air intake grille
Using a vacuum cleaner remove the fluff from the
air intake grille at the back of the appliance.
Cleaning the drum
When your laundry does not reach the desired
degree of dryness, in other words, when it turns
out either too dry or too damp, we advise you to
clean the inside of the drum with a cloth soaked
with vinegar.
This will eliminate the slight patina that has
formed in the drum (due to residues of detergent
and softeners used in the washing, and to the
lime contained in the water), which prevents the
probes from detecting the correct degree of
dryness.