Zanussi ZTE270 Notice D'utilisation page 18

125987721_EN.qxp 2007-07-02
Malfunction
When pressing a button,
the corresponding button
flashes several times.
Drying cycle ends shortly
after programme starts.
END light illuminated.
Programme inactive, Water
reservoir full light
illuminated.
Drying cycle lasts an
unusually long time.
Note: After around 5 hours
the drying cycle ends
automatically (see „Drying
cycle complete")
If you are unable to identify or solve the
problem, contact our service centre. Before
telephoning, make a note of the model, serial
number and purchase date of your machine: the
Service Centre will require this information.
18
09:38 Page 18
Possible cause
• Washing protection. After
the start of the programme,
the option can no longer be
set.
• Not enough washing loaded
or washing loaded is too dry
for selected programme.
• Condensate tank is full.
• Lint filter clogged.
• Heat exchanger clogged
with lint.
• DELICATE button pressed
and load volume too big.
• Load volume too big.
• Laundry insufficiently
predrained.
Important:
If you call out an engineer to a fault listed below,
or to repair a fault caused by incorrect use or
installation, a charge will be made even if the
appliance is under guarantee.
Solution
• Turn the programme knob to
"0" Set the programme again
• Select time programme or
higher drying level (e.g.
EXTRA DRY instead of
CUPBOARD ).
• Empty condensate tank, then
start programme with
START/PAUSE button.
• Clean lint filter
• Clean heat exchanger.
• DELICATE is only suitable for
use with loads of up to 3 kg!
• Reduce load volume.
• Laundry must be adequately
pre-drained.