Emptying The Water Reservoir; Cleaning The Air Intake Grille; Cleaning The Drum - Zanussi ZTE240 Mode D'emploi

125983101.qxp 2006-03-13
Clean it with a brush and rinse it under the shower if
necessary.
P0639
Also clean the outside, removing all fluff.
Clean the rubber seal round the condenser cabinet
and in the inner part of the small door with a damp
cloth.
Important! Do not use pointed objects or utensils to
clean the spaces between the plates, as this could
damage the condenser and make it permeable.
Re-fit the condenser, turn the red stops upwards
and close the door.
Do not use this appliance if the condenser
has not been fitted.

Emptying the water reservoir

Water extracted from the laundry condenses inside
the machine and is collected in a reservoir.
The reservoir must be emptied after each drying
cycle to ensure efficient operation when the
machine is next used. The pilot light
you this operation.
Proceed as follows:
• Open the small door at the lower part of the
cabinet
• Turn the yellow stop upwards
• Pull out the reservoir
• Open the small cover and let water flow down
• Close the small cover and re-insert correctly the
reservoir
• Push it until it clicks and turn the yellow stop
downwards to lock firmly it
• Close the small door and press the
START/PAUSE button again to allow the
programme to continue. .
13:13 Page 31
reminds
P1202
If this is not done the pilot light
next drying and the programme stops, leaving the
laundry damp. The buzzer will sound for 1 minute.
After emptying and inserting the reservoir the
START-button has to be depressed again to
allow the programme to continue.
Handy tip: The condensed water may be used in a
steam iron or to top up a battery, etc. In this case it
must be filtered (e.g. through a coffee filter).

Cleaning the air intake grille

Using a vacuum cleaner remove the fluff from the air
intake grille at the back of the appliance.
P1162

Cleaning the drum

When your laundry does not reach the desired
degree of dryness, in other words, when it turns out
either too dry or too damp, we advise you to clean
the inside of the drum with a cloth soaked with
vinegar.
This will eliminate the slight patina that has formed
in the drum (due to residues of detergent and
softeners used in the washing, and to the lime
contained in the water), which prevents the probes
from detecting the correct degree of dryness.
31
comes on during