Cleaning And Maintenance - Zanussi ZTE283 Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

audible confirmation of:
• cycle end
• anti-crease phase start and end
• cycle interruption
• error
TIME
after setting the Time programme. You can select a
programme duration from 10 mins to 2 hrs in 10-mi-
nute steps.
DELAY START
allows to delay the start of a drying programme from
minimum of 30 min. to maximum of 20 hours. Press
the Delay Start button repeatedly until the desired delay
start is shown on the display
Setting child lock
The child lock can be set to prevent a programme being
accidentally started or a programme in operation being
accidentally changed. The child lock function locks all
buttons and the programme selector. The child lock can
be activated or deactivated by holding down the DELI-
CATE and LONG ANTI-CREASE buttons simultaneously
for 5 seconds.
– Before programme is started: Appliance cannot be
used
– After programme is started: Programme in operation
cannot be changed
The icon
appears in the display to indicate that the
child safety device is activated.
The child safety device is not deactivated once the pro-
gramme comes to an end.
If you want to set a new programme, you must first de-
activate the child safety device.
Starting the programme
Press the Start/Pause button. The programme starts.
The programme progress is shown by elapsing dry time
on the LCD.

Cleaning and maintenance

Cleaning fluff filters
The filters collect all the fluff which accumulates during
drying. To ensure that the dryer works perfectly, the fluff
24
Changing programme
To change a programme which is running, first cancel it
by turning the programme selector dial to
new programme and press the START/PAUSE button.
The programme can no longer be changed directly
once the programme has started. If nevertheless
there is an attempt to change the programme on the pro-
gramme knob, the programme progress display and the
maintenance indicators flash. If an option button (exclud-
ing the BUZZER button) is pressed,
display. The drying programme is not however affected
by this (laundry protection).
Drying cycle complete / removing laundry
Once the drying cycle is complete, the display shows the
anti-crease icon and flashing as well as warning
lamps: FILTER and FULL TANK. If the BUZZER button has
been pressed, an acoustic signal sounds intermittently for
about one minute.
The drying cycles are automatically followed by an
anti-crease phase which lasts around 30 minutes.
The drum rotates at intervals during this phase. This keeps
the laundry loose and free of creases. The laundry can be
removed at any time during the anti-crease phase. (The
laundry should be taken out towards the end of the anti-
crease phase at the latest to prevent creases from form-
ing.)
1. Open door.
2. Before removing the laundry, remove fluff from the
micro-fine filter. It is best to use a damp hand for this
purpose. (See "Cleaning and maintenance" chapter.)
3. Remove laundry.
4. Turn the programme selector to
5. Close the door.
After each use
• Clean the filters.
• Empty the water reservoir.
filters (fine filters and fluff filters) must be cleaned after
each drying cycle.
. Select the
appears on the
off.

Publicité

Table des Matières
loading

Table des Matières