Installation - Zanussi ZTE270 Notice D'utilisation

125987721_EN.qxp 2007-07-02

Installation

Unpacking
Slide out the polythene bag with the polystyrene
stuffing before using the appliance Pull off
adhesive strips from inside machine on top of
drum.
Should the appliance be moved, it must be
transported vertically.
The appliance must not be installed behind a
lockable door, a sliding door or a door with a
hinge on the opposite side to that of the
appliance.
Positioning
It is recommended that, for your convenience, the
machine is positioned close to your washing
machine.
The tumble dryer must be installed in a clean
place, where dirt does not build up.
Air must be able to circulate freely all round the
appliance. Do not obstruct the front ventilation
grille or the air intake grilles at the back of the
machine.
To keep vibration and noise to a minimum when
the dryer is in use, it should be placed on a firm,
level surface.
Once in its permanent operating position, check
that the dryer is absolutely level with the aid of a
spirit level. If it is not, raise or lower the feet until it
is.
The feet must never be removed. Do not restrict
09:38 Page 23
the floor clearance through deeppile carpets,
strips of wood or similar. This might cause heat
build-up which would interfere with the operation
of the appliance.
Important
The hot air emitted by the tumble dryer can reach
temperatures of up to 60°C. The appliance must
therefore not be installed on floors which are not
resistant to high temperatures. When operating
the tumble dryer, the room temperature must not
be lower than +5°C and higher than +35°C, as it
may affect the performance of the appliance.
Stacking kit
A special stacking kit is available through your
dealer, to enable the mounting of the dyer on top
of a front loading washing machine with cover's
depth between 48 and 60 cm.
Read carefully the instructions supplied with the
kit.
Door reversal
To make it easier to load or unload the laundry
the door can be reversed.
23