Led On The Charger; Assembling The Garden Pruner; Cutting Attachment - Stihl GTA 26 Notice D'emploi

13 Assembling the Garden Pruner

To determine the battery's state of charge:
1
► Insert the battery.
► Press the button (1).
The LEDs on the garden pruner will glow or flash green for
about 5 seconds and indicate the state of charge (see
illustration).
For example:
If four green LEDs glow continuously: full charge.
If one green LED is flashing: less than 20 % charge.

12.2 LED on the Charger

One LED shows the status of the charger and battery. The
LED can glow or flash green or red.
If the LED glows green continuously or flashes
green: the battery is being charged.
0458-694-8221-A
80-100%
60-80%
40-60%
20-40%
0-20%
For more information, @ 23.
13 Assembling the Garden Pruner

13.1 Cutting Attachment

If non-matching components are used, the cutting
attachment will be damaged beyond repair after a short
period of operation, and the chain could de-rail, resulting in
serious or fatal personal injury.
A cutting attachment consists of the chain, guide bar and
chain sprocket.
If the LED flashes red: there is no contact
between the battery and the charger. Remove
and reinsert the battery.
or
The battery has a malfunction and must be
replaced. Do not use or charge the battery.
or
The charger has a malfunction. Have it checked
by an authorized STIHL servicing dealer before
use.
If the LED glows red continuosly: The battery is
too hot or too cold for charging. Allow the battery
to warm up or cool down gradually at an ambient
temperature of about 50 °F to 68 °F (10 °C to
20 °C).
WARNING
English
23