Frigomat T4s 05 Manuel D'utilisation Et D'entretien page 42

5.3.3 GRANITA PRODUCTION
GR1 GRANITA CYCLE
Here it is possible to set and program the consistency values, exactly as the ice cream
semi-automatic production cycle.
- By the press of the GRANITA pushbutton both the display – showing GR1 – and UP-
ENTER-DOWN pushbuttons lighten. Now the machine is ready for the selection of the
desired granita program.
- Press ENTER pushbutton to confirm the GR1 cycle selection.
- The display shows the last consistency value set. Press UP and DOWN pushbuttons
to increase or decrease the required consistency value (within a range between 120
and 180). After setting the required value, press the ENTER pushbutton to confirm the
program and start the cycle. The recommended value ranges between 140 and 160.
- During this cycle the compressor and the agitator keep on working without
interruptions. Once the programmed consistency value has been reached, the
GRANITA pushbutton blinks and an intermittent beep is released.
- Press the STOP pushbutton and deliver the product.
- If this is not possible, the agitator keeps on rotating until the consistency level falls by a
predetermined percentage value and the granita PRESERVATION phase begins,
which can be stopped at any time with the delivery of granita.
GR2 GRANITA CYCLE
The programming of this cycle is based on the working time and cyclic agitation control.
- Pressing the GRANITA pushbutton both the display – showing GR1 – and UP-
ENTER-DOWN pushbuttons lighten. Now the machine is ready for the selection of the
required granita program.
- Press UP or DOWN pushbuttons to select the GR2 cycle.
- Press ENTER pushbutton to confirm the GR2 cycle selection.
- The display shows the last selected time. Press UP and DOWN pushbuttons to
increase or decrease the processing time for the production of granita. (within a range
between 1' to 10'). Once the required value has been set, press ENTER to confirm the
program and start the cycle. The recommended value ranges between 3' and 7'.
- During this cycle the compressor keeps on working without interruptions, while the
agitator stops for 10 seconds and runs for half a second alternately. After the
programmed time has elapsed, the PRODUCTION pushbutton blinks and an
intermittent beep is released. Press the STOP pushbutton and deliver the product.
The GR2 program DOES NOT provide the automatic conservation of the product at the
end of the cycle.
ENGLISH - 16