Frigomat T4s 05 Manuel D'utilisation Et D'entretien page 35

position, unlock the door by lifting the lever and turn it towards the left. In case of model
T5S, turn the two locking knobs outwards, pull the door, which is now disengaged and
withdrawable.
• Remove the agitator, check and lubricate the agitator stuffing box with FRIGOMAT
lubricant (provided as standard).
• The ideal temperature shall range between 15°C and 35°C.
• The ideal humidity shall range between 30 and 60%.
FRIGOMAT s.r.l. declines any liability for damages to persons and/or things due to a
wrong installation and/or the non-compliance with the industrial accident prevention
standards. Never touch the machine with hands, both when it is on duty and during
cleaning and maintenance operations, without making sure that the machine has been
stopped by means of pushbutton STOP and the master switch has been turned off. Never
clean the machine by means of high pressure jets of water. Never close the cut-off cock
while the machine is running (T4S). Pay attention not to damage the feeder. In case of
necessity, make it be replaced.
In case the machine provided with water-cooling (T4S) is left at a room temperature
inferior to 0°C, it is necessary to run off all water present inside the condenser before
starting up the machine.
9 - ENGLISH
• For three-phase versions only, check the correct
direction of rotation of the agitator motor: apply
voltage to the
pushbutton and check that the agitator direction of
rotation is counterclockwise through the hopper
grid. If not, exchange the wires in the feeder
(T4S).
• Press STOP pushbutton to stop the machine.
Avoid making the machine running empty for a
long time.
• Model T4S: when the machine is in stop
machine, press DELIVERY