Connection - Pelgrim MWA130 Mode D'emploi

INSTALLATION

Connection

Electrical connection
The mains power supply must correspond to the rating indicated on the
plate situated inside the hood.
If provided with a plug, connect the hood to a socket in compliance with
current regulations and positioned in an accessible area.
If not fitted with a plug (direct mains connection) or if the plug is not
located in an accessible area, fit a double pole switch that will allow
complete disconnection from the mains under the conditions of
overvoltage category III, in accordance with installation instructions.
Attention! Before re-connecting the hood circuit to the mains supply
and checking that it works correctly, always check that the mains cable
is properly fitted.
The hood is provided with a special power cable; if the cable is
damaged, request a new one from our technical services department.
EN 11