Operation With A Connected Hob; Making The Connection Between Cooker Hood And Hob - Pelgrim OSWA0980 Serie Notice D'utilisation

OPERATION WITH A CONNECTED HOB

Making the connection between cooker hood and hob

EN 10
The connection to an AutoAir hob is not active by default. First the
connection to the hob must be activated.
At the same time, a setting must also be made on the hob; see the hob
manual for this.
Check our website for the full range of hobs that can be connected to
your cooker hood.
Making a connection
1. Turn off the hood and the lighting.
2. Touch and hold the automatic mode button for three seconds.
▷ On the LED status bar the automatic mode indicator and the
timer indicator will flash simultaneously for a maximum of two
minutes.
3. On your hob, activate the pairing mode in the user menu (see the
hob manual). The connection to the hob is established.
▷ The connection is successful when on the LED status bar the
automatic mode indicator and the timer indicator are illuminated
continuously for four seconds.
If the automatic mode indicator and the timer indicator are no longer
illuminated within two minutes, the connection was not successful.
Repeat the procedure. If necessary, clear the hood's memory (see
"Disconnecting").
Disconnecting
1. Turn off the hood and the lighting.
2. Touch and hold the automatic mode button for three seconds.
▷ On the LED status bar the automatic mode indicator and the
timer indicator will blink five times simultaneously.
▷ The hob is no longer connected.