Operation With A Connected Hob; Making The Connection Between Cooker Hood And Hob - Pelgrim ISWA990 Serie Notice D'utilisation

OPERATION WITH A CONNECTED HOB

Making the connection between cooker hood and hob

The connection to an AutoAir hob is not active by default. First the connection to the hob must
be activated.
At the same time, a setting must also be made on the hob; see the hob manual for this.
Check our website for the full range of hobs that can be connected to your cooker hood.
Making a connection
1. Turn off the hood and the lighting.
2. Press and hold the lighting button for three seconds.
The indicator lights on the on/off button and speed button 2 will flash simultaneously for
▷
a maximum of two minutes.
On your hob, activate the pairing mode in the user menu (see the hob manual). The
▷
connection to the hob is established.
3. The connection is successful when the indicator lights on the on/off button and speed
button 2 are illuminated continuously for two seconds.
If the indicator lights on the on/off button and speed button 2 are no longer illuminated
within two minutes, the connection was not successful. Repeat the procedure. If
necessary, clear the hood's memory (see "Disconnecting").
Disconnecting
1. Turn off the hood and the lighting.
2. Press and hold the on/off button for three seconds.
▷ The indicator lights on the on/off button and speed button 2 will blink five times
simultaneously.
▷ The hob is no longer connected.
EN 8