Maintenance Plan - PrimAster PMAMT 40 Manuel D'utilisation

GB ENGLISH
Warning! Always remove the battery before checking and setting work.
Replacing the guide bar and saw chain
WARNING
Wear protective gloves.
A dull or improperly sharpened chain can cause
excessive motor speed during cutting which may
result in severe motor damage.
Failure to replace or repair a damaged chain can
cause serious injury.
The saw chain is sharp. Always wear protective
gloves when performing maintenance to the chain.

Maintenance plan

Daily check
Bar lubrication
Chain tension
Chain sharpness
For damaged parts
For loose fasteners
Chain brake function
Guide Bar
Complete saw
Troubleshooting
Check the battery capacity. A low charge level may result in more blockages. Continue working with the battery
fully charged.
The following table shows error symptoms and describes how you can remedy them if your machine is not wor-
king properly. If this does not allow you to locate and correct the problem, contact your service workshop.
Cause
Telescopic hedge trimmer is not
working
Telescopic hedge trimmer is
working irregularly
Cutting blade runs hot
Poor cutting performance /
unclean cut
48
Before each use
Before each use and
frequently
Before each use, visual
check
Before each use
Before each use
Before each useInspect
and clean
Before each use
After each use
Error
Battery is empty
Battery is defective
Internal loose contact
On/off switch is defective
Too much friction due to too
little lubricant
Blunt cutting blade
Replacement parts
Spool 78001921
Blade 73040106
Chain 91P033X
Guide Bar 080SDEA318
Chain must be fitted with bar from the same
manufacturer according to above combinations.
Remedy
See "Charging the battery"
Have it replaced by our
technical service
Visit a specialist workshop
Visit a specialist workshop
Apply lubricant spray
Sharpen/replace cutting blade