Safety Instructions - PrimAster PMAMT 40 Manuel D'utilisation

WARNING: The declared vibration emission level represents the main applications of the tool. However if the tool is
used for different applications, with different accessories or poorly maintained, the vibration emission may differ. This
may significantly increase the exposure level over the total working period.
The vibration emission level will vary because of the ways in which a power tool can be used and may increase above
the level given in this information sheet.
The vibration emission level may be used to compare one tool with another.
It may be used for a preliminary assessment of exposure.
An accurate estimate of the vibratory load should also take into account the times when the tool is shut down or when
it is running but not actually in use. This may significantly reduce the vibratory load over the total working period.
Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and
the accessories, keep the hands warm, organisation of work patterns.

SAFETY INSTRUCTIONS

This device is not suitable for use by persons
(including children) with restricted physical, sensory
or mental abilities or insufficient experience and
knowledge or persons who are not familiar with the
instructions. You must never be allowed to use the
machine.
Read and understand the operating instructions before
using the appliance. Familiarise with the control elements
and how to use the appliance properly.
Abide by all the safety measures stated in the service
manual. Act responsibly toward third parties. The operator
is responsible for accidents or risks to third parties.
Keep children and other persons including animals in a
safe distance when using the appliance. Minimum safe
distance is 15 m.
Do not allow persons unfamiliar with the power tool or
these instructions to operate the power tool.
Local regulations may stipulate the minimum age of the user.
WARNING
Wear personal protective equipment.
• Always wear goggles when using the machine.
• Wear ear protectors!
• Wear solid shoes and long trousers.
• Do not wear loose clothing or jewels. Hear, clothing and
gloves must be out of reach of moving parts as they
could get caught by the rotating parts. Do not use the
appliance when barefooted or in open sandals.
• Never replace the non-metallic cutting device (coil head)
with a metallic cutting device (coil head).
• Take a firm stance to maintain balance during operation
and be sure to use the included carrying strap.
• Position the shoulder strap such that it goes over your
shoulder, crossing your chest and back.
• Hook the shoulder strap into the fastening eyelet.
• Adjust the strap length such that the shoulder strap
quick-release is at hip height
• The quick release of the shoulder strap regularly and be-
fore each use for damage and check correct function. In
the event of damage or suspected damage immediately
from check authorized specialists and Have it replaced
if necessary.
• Pull on the for a quick release function
• red ribbon of the quick release.
Provide adequate lighting or good lighting conditions
when working with the machine. Poor lighting/light
conditions represent a high safety risk.
Do not use the appliance in bad weather, especially when
there is a risk of storm.
Do not use the appliance if you are tired, ill, under influ-
ence of drugs, alcohol drinks or medicaments.
Do not overreach. Keep proper footing and balance at all times.
Walk! Never run!
Be careful when going backwards – risk of tripping!
Provide a safe posture, especially on slopes.
Despite the observance of the operating instructions there
still may be some hidden residual risks.
GB ENGLISH
37