MSA S-CAP Manuel D'instruction page 10

1. Description and Ordering Information
The products described in these Instructions for Use are in accordance with
Regulation 89/686/EEC. These Instructions for Use apply to MSA filtering smoke
hoods according to EN 403:2004.
Description
S-CAP in cardboard box
S-CAP in wall box
S-CAP in fireman's pack (pg. of 3)
S-CAP in pouch
Class M: suitable for carrying along
Class S : suitable for stationary storage
2. Selection and Use
Filtering smoke hoods are used exclusively for self-rescue in case of fire. They
are intended for one-time use only and for short duration.
Filtering smoke hoods are respiratory protective devices dependent on the
ambient air and do not protect against oxygen deficiency.
Users with facial hair like beards or sideburns or anomalies in the face are not
likely to achieve a tight fit since the facepiece-to-face fit may be broken. This
may also occur in the case of extreme face sizes (e.g. children) or face shapes.
Due to its wide design, the S-CAP is also suited for persons wearing spectacles.
3. Donning
Remove S-CAP from box, resp. pack and don according to Fig. 1- 4.
4. Storage, Storage Life
The S-CAP is stored in cool, dry and clean ambient air. Do not open box or pack
or foil bag prior to use. In case of damaged or opened foil bag, replace S-CAP.
The end of storage life is indicated on the device (hourglass).
At the end of the storage life contact MSA to determine if it can be extended.
10
Class Part No.
M 10064644
S 10064645
M 10064646
M 10081637
S-CAP