Installation And Wire Connection - Clarion FZ259 Mode D'emploi Et Manuel D'installation

9. INSTALLATION AND WIRE
CONNECTION
1. Before Starting
1. This set is exclusively for use in vehicles with
a negative ground 24 V power supply.
2. Read these instructions carefully.
3. Be sure to disconnect the battery " " terminal
before starting. This is to prevent short circuits
during installation. (Figure 1)
2. General Cautions
1. Do not open the case. There are no user serviceable parts inside. If you drop anything into the unit
during installation, consult your dealer or an authorized Clarion service center.
2. Use a soft, dry cloth to clean the case. Never use a rough cloth, thinner, benzine, or alcohol etc.
For tough dirt, apply a little cold or warm water to a soft cloth and wipe off the dirt gently.
3. Cautions on Installation
1. Prepare all articles necessary for installing the
source unit before starting.
o
2. Install the unit within 30 of the horizontal
plane. (Figure 2)
3. If you have to do any work on the car body,
such as drilling holes, consult your car dealer
beforehand.
Battery
Figure 1
o
Max 30
Figure 2
4. Installation the Source Unit
1. Place the mounting bracket into the instrument
panel, use a screwdriver to bend each stopper
of the mounting bracket inward, then secure the
stopper.
2. Wire as shown in Section 7 .
3. Insert the source unit into the mounting bracket
until it locks.
4. Take care of the top and bottom of the trim ring
and mount it so that all the hooks are locked.
Note: 1. Some car models require special mounting
kits for proper installation. Consult your
Clarion dealer for details.
2. Fasten the front stopper securely to prevent
the source unit from coming loose.
Notes of installation:
Before installation, please make sure proper connections are conducted and the unit operates
normally. Improper connection may result in damage to the unit.
Use only accessories designed and manufactured for this unit and other unauthorized
accessories may result in damage to the unit.
Before installation, please fasten all power cables.
DO NOT install the unit in the place where close to hot area to prevent damage to electrical
components such as the laser head.
Install the unit horizontally. Installing the unit more than 30 degree vertically may result in worse
performance.
To prevent electric spark, connect the positive pole first and then the negative pole.
Unit installation
1. Insert mounting bracket into dash board,
choose appropriate mounting tab according
to the gap width, bending the mounting tab
outwards with a screwdriver to fix the
mounting bracket in place.
2. Slide the unit into the bracket until you hear a
click sound.
Screwdriver
Dashboard
Mounting Bracket
Console opening dimensions
7-3/16"
(182 mm)
Hole
Trim ring installation
Attach the trim ring around the front panel. Take
care of the top and bottom of the trim ring and
mount it so that all the hooks are locked.
Top
Bottom
FZ259
9