Port Hole - Vestfrost VTS 258 Mode D'emploi

Port Hole

Some models are equipped with an extra porthole, for use of an external sensor etc. Gain
access to the porthole via the appliances rear side.
1. Remove the two screws (TX20).
3. Remove the two rubber plugs from the
porthole (1 in the top & 1 inside the
appliance).
5. Press the rubber plug down, so it closes
tightly around the sensor.
2. Lift up the cover and place it on the ap-
pliance top.
4. Guide the sensor through the top cover
protection bushing, through the porthole
and into the appliance.
6. Place the top cover in closed position
and remount the two screws (TX20).
13
GB