Cleaning And Maintenance - Vestfrost VTS 258 Mode D'emploi

GB

Cleaning and maintenance

Before cleaning, disconnect the power sup-
ply and remove all loose fittings.
The appliance is best cleaned using warm
water (max. 65°C) with a little mild, per-
fume-free detergent. Never use cleaning
agents that scour. Use a soft cloth. Rinse
with clean water and dry thoroughly. It is
important to prevent water from entering the
control panel.
fig. 13
The sealing strips around the door must be
cleaned regularly to prevent discolouration
and prolong service life. Use clean water.
After cleaning the sealing strip, check that it
continues to provide a tight seal.
It is recommended that the wire and tubular
condensers on the rear of the appliance be
cleaned.
The ventilation grille, the condenser, the
compressor and the compressor compart-
ment must also be kept free of dust and dirt.
Clean it with a vacuum cleaner regularly.
Remove the lower panel from beneath the
door by loosening the two screws
(see fig 12)
Do the same on the back (see fig. 13)
OBS: If the appliance is not to be used for
any length of time, switch it off, disconnect
the power supply, empty it, clean the inside
and leave the door open to allow air circula-
tion and prevent smells.
fig. 12
26