Installation Procedure - Toto DuoFit WT151M Manuel D'installation Et D'utilisation

Installing the In-Wall Tank System
Loosen the bolts on the adjustable
legs and place the carrier into the
wood frame.
Adjust the carrier to the desired
height with reference to the
Finished Floor (see Table 1 for
guide) and marked on the wood
frame.
Tighten the two bolts on the legs
to secure the height of the carrier.
Mark the location for drilling
pilot holes for the screws to
secure the carrier to the wood
frame.
There are six (6) screws for the
side (3 on each side) and two on
the feet. Make sure the carrier
is fl ush with the wood frame
before placing the markings.
Remove the carrier from the
wood frame, drill six (6) 1/8"
holes on the wall stud (Trimmer/
Jack) and two (2) on the subfl oor
(plywood); for concrete, drill
3/8" holes for anchors.
For vertical drain installation, drill a
3-3/4" hole on the subfl oor 3-1/2"
from the front of studs.
3-½"

INSTALLATION PROCEDURE

A
A
A
4
A
1
A
A
B
B
For left or right drain connection,
it is recommended to install the
drain at 45º or more from the outlet
horizontal.
45°
H
A
Ø 1/8" [3mm]
2
B
2
Ø 1/8"
[3mm]
1
45°