Before Installation; Installation Procedure - Toto CST703X.10 Manuel D'installation Et D'utilisation

Masquer les pouces

Table des Matières

Les langues disponibles

 Read these instructions thoroughly before beginning work.

 Please leave these instructions for customers. These instructions contain mainte-

nance and warranty information.

 If necessary, remove the existing toilet.

IMPORTANT!

Due to the powerful performance of our Cyclone, G-Max, E-Max and Power Gravity

ﬂushing systems, they are not speciﬁed for back-to-back installations. The only

means of installing these toilets in a back-to-back situation is when the toilet drain

connections incorporate a WYE ﬁtting. Please contact your builder or contractor prior

to this installation.

Double Combination WYE / 1/8 Bend

For your new TOTO toilet to ﬁt correctly the rough-in, the distance between the

ﬁnished wall to the center of the closet ﬂange, must be at least 12 inches for most

models. Models with 10" rough-in have model numbers ending with ".10", for

example C744EF.10."

1) Clean any debris out of the closet ﬂange and then

install new mounting bolts (not supplied) into the

slots of the closet ﬂange (see Ill. 1). The head of the

bolt should be inserted into the slot with its threads

facing upward.

2) Carefully turn the toilet upside down onto some

padding. Firmly press a new bowl wax ring (not

supplied) onto the circular recess around the toilet

bowl's horn (see Ill. 2). Turn the toilet upright and

gently lower into position over the closet ﬂange.

With toilet properly aligned, press ﬁrmly on both

sides of toilet rim to set the bowl wax ring.

C AUTION: Do not move the bowl after the bowl

wax ring is set. Thread nuts and tighten evenly

until bowl is snug to closet ﬂange. Install the bolt

caps.

C AUTION: Do not over-tighten the nuts as damage

to the china bowl may result.