Care And Cleaning; Installation Procedure - Toto CST646F Manuel D'installation Et D'utilisation

Use a detergent or non abrasive toilet cleaner and a soft bristled plastic brush to
clean your toilet. To remove hard water stains, use vinegar or lime dissolving
cleaner and a non scratch scour pad made for porcelain. Allow a little contact time
to allow the cleaner to dissovle the buildup. Do not spray cleaner directly onto the
button, instead wipe it using a dampened soft cloth with diluted dishwashing
detergent and dry it with another soft cloth.
Do not spray cleaner directly onto the button, instead wipe it using a dampened soft cloth with
diluted dishwashing detergent and dry it with another soft cloth. Do not use bleach or products
that contain acid or alkaline detergents in their ingredients. Do not use metal scrub brushes or
steel wool.
NOTICE
DO NOT USE IN-TANK BOWL CLEANERS.
The use of high concentrations of chlorine or chlorine-related products can seriously damage
fittings in the tank. This damage can cause leakage and property damage. TOTO® shall not be
responsible or liable for any tank fitting failure or damage caused by the use of in-tank bowl
cleaners.
1. Open the Unifit Rough-In packaging. Follow the
Unifit Rough-In Installation instruction to complete
the rough-in installation (ill. 1).
2. Place the template into position and follow its
instructions to prepare for installing the toilet.
Do not move the Unifit Rough-In on the
NOTICE
Floor Flange after wax seal is set. If this
notice is disregarded, discard the wax
ring and replace with new wax ring.
3. Place the toilet over the Unifit Rough-In and the two
mounting blocks, by aligning the toilet outlet with
the Unifit Rough-In opening (ill. 2).
Insert the toilet all the way into position.
NOTICE
If this notice is disregarded, leakage
may result.
Check for rocking. If needed, use shims to
NOTICE
prevent the toilet from rocking.
4. Align the toilet perpendicular to the back wall
and parallel to side walls; it should not sit
crooked or diagonal (ill. 3).

CARE AND CLEANING

INSTALLATION PROCEDURE

4
ill.1
Wax seal
Screw
Anchor
ill.2
ill. 3
Nut
Washer
Mounting block