Toto WASHLET Manuel D'installation

Follow these instructions and follow all safety procedures. See the Washlet installation manual for additional safety precautions.
Make sure you have all the parts in the package:
A-1 A-2
* Included for installations outside US and Canada.
If bowl has not been installed:
1) Place the back of A-13 (H0C031)
30 mm from the wall. Use pencil to
mark the location of the four holes
in A-2 template.
2) Use installation instructions for
toilet, but do NOT install the
junction valve!
WAshLeT
®
insTALLATion mAnuAL
incLuded PArTs
A-3 A-4
A-5 A-6
BeFore insTALLATion
If bowl is already installed:
1) Disconnect junction valve if not
already disconnected and set it aside.
2) Place the center of A-2 template at
60 mm from wall and 100 mm from
center of toilet.
3) Use pencil to mark the locations of
the four holes in A-2 template.
rough-in dimensions
Location of A-2 for wall water supply (Type 1)
900 800 700 600 500 400 300
800
700
600
500
400
300
Location of A-2
200
100
0
900 800 700 600 500 400 300
Location of A-2 for floor water supply (Type 2)
900 800 700 600 500 400 300
0
100
200
Location of A-2
300
400
500
600
700
900 800 700 600 500 400 300
eXTension hose KiT
A-7 A-8
200 100 0 100 200 300
Do not install beyond 50 mm line
100 200
200 100 0
Distance from center of toilet (mm)
100 200
200 100 0
320
70
110
250
250
100 200
200 100 0
Distance from center of toilet (mm)
A-11* A-12
A-9 A-10
wall
110 mm
mark
400 500 600 700
800
700
600
500
400
300
200
100
0
300 400 500 600 700
300 400 500 600 700
0
Do not install beyond
60 mm line
100
200
300
400
500
600
700
300 400 500 600 700
A-13
A-2 template