Elica ENT432BL Guide D'utilisation, D'entretien Et D'installation page 7

Caution! Strictly observe the following instructions:
- The device must be disconnected from the electrical
network before performing any installation work.
- Installation or maintenance must be performed by a
qualified technician, in compliance with the
manufacturer's instructions and with local safety
regulations. Do not repair or replace any part of the
device unless specifically stated in the operating
manual.
- Earthing the device is compulsory.
- Do not use multiple sockets or extension cords.
- Once installation is complete, the electrical
components must no longer be accessible by the
user.
- The device and its accessible parts heat up during
use. Be careful not to touch the heating elements.
- Ensure that children do not play with the device;
keep children away and supervise them, as the
accessible parts may become very hot during use.
- For people with pacemakers and active implants it is
important to check, prior to using the induction hob,
that their pacemaker is compatible with the device.
- During and after use, do not touch the heating
elements of the device.
- Avoid contact with cloths or other flammable
materials until all the device components have
sufficiently cooled.
- Do not place flammable materials on or near the
device.
- Overheated fats and oils easily catch fire. Supervise
the cooking of foods rich in fat and oil.
- If the surface is cracked, switch off the device to
avoid the possibility of an electric shock.
- The device is not intended to be run with an external
timer or a separate remote control system.
-Unattended cooking on a hob with oil or fat may be
dangerous and may cause a fire.
- The cooking process must be supervised. A short-
term cooking process must be constantly monitored.
- NEVER attempt to put fires out using water. Instead,
turn off the device and smother the flames, for
example with a lid or a fire blanket. Fire hazard: do not
rest objects on the cooking surfaces.
- Do not use steam cleaners.
- Before connecting the device to the electrical
network: check the data plate (on the bottom of the
device) to ensure that the voltage and power
correspond to the network values and that the
connection socket is suitable. If in doubt, consult a
qualified electrician.
6