Electrical & Installation Requirements; Electrical Requirements; Before Installing - Elica ENT432BL Guide D'utilisation, D'entretien Et D'installation

Electrical & Installation requirements

Electrical requirements

Fig. 2
- Disconnect the device from the electrical network
-The installation must be performed by professionally qualified personnel familiar
with the applicable installation and safety standards.
-The manufacturer declines any liability to people, animals or things in the case of
failure to follow the guidelines provided in this chapter.
-Make sure that the voltage on the rating plate on the bottom of the device
corresponds to that of the house where it will be installed.
-Do not use extension cords.
- Earthing is required by law
IMPORTANT
Observe all governing codes and ordinances.
It is the customer's responsibility:
To contact a qualified electrical installer.
To assure that the electrical installation is adequate and in
conformance with National Electrical Code, ANSI/NFPA 70
— latest edition*, or CSA Standards C22.1-94, Canadian
Electrical Code, Part 1 and C22.2 No.0-M91 - latest
edition** and all local codes and ordinances.
If codes permit and a separate ground wire is used, it is
recommended that a qualified electrician determine that the
ground path is adequate.
Do not ground to a gas pipe.
Check with a qualified electrician if you are not sure range
hood is properly grounded.
Do not have a fuse in the neutral or ground circuit.
IMPORTANT
Save Installation Instructions for electrical inspector's use.
The appliance should be connected directly to the fused
disconnect (Or circuit breaker) box through metal electrical
conduit.
Wire sizes must conform to the requirements of the National
Electrical Code ANSI/NFPA 70 — latest edition*, or CSA
Standards C22.1-94, Canadian Electrical Code Part 1 and
C22.2 No. 0-M91 - latest edition** and all local codes and
ordinances.
A U.L.- or C.S.A.-listed conduit connector must be provided
at each end of the power supply conduit (at the appliance
and at the junction box).
Copies of the standards listed may be obtained from:
* National Fire Protection Association Batterymarch Park Quincy,
Massachusetts 02269
** CSA International 8501 East Pleasant Valley Road Cleveland,
Ohio 44131-5575

Before installing

At least two people are necessary for installation.
Wear gloves to protect against sharp edges.
The exhaust air should not be vented into a wall, a ceiling,
or a concealed space of a building
To eliminate the risk of burns or fire by reaching over heated
surface units, cabinet storage space located above the
surface units should be avoided. If cabinet storage is to be
provided, the risk can be reduced by installing a range hood
that projects horizontally a minimum of 5 inches beyond the
bottom of the cabinets.
1
8