Mounting Single Valves - Burkert MP07 Instructions De Service

Blocs multiples et profil pneumatique modulaire
Masquer les pouces Voir aussi pour MP07:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Mounting single valves

Fix the single valve directly to the wall using M4 screws.(Figure: Installation, Initialisation and Service -
Mounting single valves , Manual override, Pneumatic position indicator )
ATTENTION! When mounting, do not distort the valve body!
Plug-in connections
NOTE
For plug-in connections, the hose lines must meet the following requirements:
• Minimum rigidity of 40 Shore D (to DIN 53505 or ISO 868);
• External diameter corresponding to DIN 73378 (max. permissible deviation ± 0.1 mm
• Without burr, cut at right-angles and with undamaged circumference;
• The hose lines must be pushed into the plug-in connectors up to the stop.
Dismantling the plug-in connections
To release the line, press in the pressure ring and pull out the hose line.
M4 screws
for wall mounting
the single valve
Figure: Mounting single valve, Manual override, Pneumatic position indicator
from nominal dimension);
I
, I
NSTALLATION
NITIALISATION AND
Manual override
to operate the valve manually, turn the manual
override by 90° in the direction of the arrow
Indicating pin for indicating the pneumatic
position
With the valve not switched, the red indicating
pin can be pressed in. If the valve has been
switched, the indicating pin moves outwards,
and remains in this position. The indicating pin
must be pushed in again for every functional
test.
Designation plate (can be removed for
marking / engraving)
Port 14
• not used in the standard model
• used as an auxiliary pilot air connection
and as the connection for pneumatic
controls
Service ports
2 (B) and 4 (A)
S
ERVICE
6516 / 6517 - 15

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

65166517

Table des Matières