Reely Rally-Truck 1086094 Notice D'emploi page 53

Function Green LED
flashes....
(+ Beep)
1 Drive function 1x short
2 Motor brake 2x short
3 Undervoltage protection 3x short
4 Starting mode 4x short
5 Maximum braking 1x long
strength
6 Max. reverse speed 1x long +
1x short
7 Minimum braking strength 1x long +
2x short
8 Neutral range 1x long +
3x short
9 Timing 1x long +
4x short
10 Overheating protection 2x long
The grey values are the basic settings performed by the manufacturer at the time these operating instruc-
tions were drawn up. The speed controller of your vehicle may have a different basic setting; observe the
number of flashes of the red LED in this case.
Description of the setting functions:
• Function #1, green LED flashes 1x short: Drive function
The speed controller can be switched between „forwards/brake" and „forwards/brake/reverse" (reverse driving can
thus be switched off). The setting „Forward/reverse" should not be used. It is used, e.g., for „Crawler" vehicles.
• Function #2, green LED, flashes 2x short: Motor brake
If you reduce the throttle at the transmitter or move back the throttle/brake lever into the neutral position, the vehicle
will slow down automatically. The effect is thus exactly like that of the motor-braking function in a „real" car when you
release the throttle pedal without stepping on the brake pedal.
This also corresponds to the brake function of a conventional electric motor (a brushless electrical motor does not
have any strong magnets that brake the rotor).
• Function #3, green LED flashes 3x short: Undervoltage protection
If LiPo rechargeable batteries are used, then you must ensure that the low-voltage protection is activated (we
recommend at least 3.0 V per cell).
If the speed controller measures a battery voltage of 6.0 V in a 2-cell LiPo battery (fully charged approx. 8.4 V)
and a deactivation voltage of 3.0 V/cell, the speed controller first reduces the starting output or speed to 50% for
2 seconds. You can then still steer the vehicle to the edge of the route in a race. Then the speed controller switches
off the motor to avoid deep discharge of the LiPo battery.
When using am NiMH-drive battery, deactivate the undervoltage recognition. Alternatively, you can set the undervol-
tage recognition to 2.6 V/cell. Deactivation takes place at a battery voltage of 5.2 V then (the speed controller does
not recognise that a NiMH-drive battery is connected, but calculates the deactivation voltage assuming that there is
a 2-cell LiPo battery).
1x short 2x short 3x short
Forwards/brake Forwards/ Forwards/
Brake/ Reverse
Reverse
0% 5% 10%
off 2.6 V/cell 2.8 V/cell
1 (slow) 2 3
25% 50% 75%
25% 50% 75%
= Motor brake 0% 20%
6% 9% 12%
0,00° 3,75° 7,50°
On (+95 °C) Off
Red LED flashes.... (+ Beep)
4x short 1x long 1x long,
1x short
20% 40% 60%
3.0 V/cell 3.2 V/cell 3.4 V/cell
4 5 6
100%
100%
40%
11,25° 15,00° 18,75°
1x long, 1x long, 1x long,
2x short 3x short 4x short
80% 100%
7 8 9 (fast)
22,50° 26,25°
53