To Mount The Node To A Valve (Figure 1); Mounting The Node; Connecting A Weather Sensor - Hunter NODE Manuel De L'utilisateur

MOUNTING THE NODE

The NODE can easily be mounted on any Hunter plastic valve . A
specially designed valve mounting clip makes installation a snap . A
protective rubber cover is provided to prevent dirt from accumulating
on the face of the NODE .

To Mount the NODE to a Valve (Figure 1)

1 . Screw the Hunter DC latching solenoid (P/N 458200) into
the valve bonnet.
2 . Set the small open end of the NODE holder on top of the solenoid.
3 . Set the NODE controller into the large open end of the
NODE holder.
NODE holder
Figure 1

CONNECTING A WEATHER SENSOR

A Hunter Mini-Clik or Wired Rain-Clik
®
to the NODE . The purpose of this sensor is to stop watering when
weather conditions dictate .
NOTE: When the Wired Rain Sensor is interrupting
the watering, the display will show the System Off
icon , "OFF" and
1 . Cut the yellow wire loop attached to the NODE at approximately
the middle of the loop.
2 . Remove approximately ½" (13 mm) of insulation from each wire.
Attach one yellow wire to each of the wires of the weather sensor.
You can mount the rain sensor up to 100 ft (30 m) from the NODE
controller (18 AWG/1 mm minimum wire size).
3 . Secure wire connections with waterproof connectors.
Hunter Model Mini-Clik
EN
rain sensor can be connected
®
on the display.
®
6