Turning The System Off; Manual Watering - Hunter NODE Manuel De L'utilisateur

Masquer les pouces Voir aussi pour NODE:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 33
PROGRAMMING (CONTINUED)

Turning the System Off

To turn your controller off, press the
and OFF is displayed on screen . To return the controller to auto
programming mode, press the
immediately return to auto programming mode and will display the
time and battery-life indicator .

Manual Watering

Manual Watering allows the user to test each station or a program
for a specified run time . The weather sensor condition (if used) will be
disregarded in this mode .
1 .
Make sure the controller is in idle mode. Press and hold the
button until the
icon is displayed.
2 . The station number will be displayed in the lower left side of the
display along with the run time.
3 . Use the
and
buttons to select the desired station and
the
and
buttons to set the manual watering time for the
station shown.
button until the
icon
button . The controller will
4 . To manually activate a program, press the
letter (A, B, or C) will show on the screen. If a different program
is needed, press the
button until the desired program is
displayed.
5 . To stop the Manual Watering cycle, press the
time is reduced to zero.
6 . Press the
button to proceed to the next programming function
or allow controller to return to idle mode.
NOTE:
• Pressing the
running in Manual Watering mode will modify the
irrigation time for that station.
• Pressing the
Manual Watering mode will stop irrigation on the
current station and advance to the next station.
• Pressing the
Manual Watering mode will stop irrigation on the
current station and revert to the previous station.
button. The program
button until the
or
buttons when a station is
button when a station is running in
button when a station is running in
EN
10

Hide quick links:

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Node-100

Table des Matières