Operation; Before Operation; Start/Stop (Change, Rinse, Foam, Des) - Ecolab Hybrid Foamatic MA2CM Mode D'emploi

8. Operation

8.1. Before operation

Wear glasses when using the unit.
Wear gloves and be aware of
chemicals and sharp edges.
Wear suitable safety boots.
WARNING
This machine has been designed for
use with the cleaning agents supplied
or recommended by the supplier

8.2. Start/Stop (change, rinse, foam, des)

Start satellite
1. Check that water- and air supplies for the system
are open.
2. Make sure that the water and air supply to the
unit is open. For air see layout drawing. In case
of central chemical supply this must be activated
too.
3. Select requested function. Use the unit according
to the "User guide".
Stop satellite
1. Press " " to stop program if running.
2. Turn off the water supply
3. Close the air supply
4. Deactivate chemical supply by pulling up the suc-
tion hose or removing the User Pack.
It is important to shut off the water and
air when the unit is left after use .
• If the air supply is open when the unit are not in
use, air may seep into the water pipe. If this is the
case the system may have to be bled again.
It may be necessary to bleed the pipes and the unit
again after it has been closed for a longer period of
time (holidays, and the like)
190
CAUTION
The chemical supply must always be
rinsed thoroughly after use
The following procedure will clean the chemical sup-
ply for detergents and/or remains of disinfectants.
1. Remove User Pack or standard can.
2. Hold the rinsing bottle with clean water tightly
against the suction opening (with User Pack). Alterna-
tively, you can place a User Pack with clean water in
the holder or – without User Pack – place the hose in
a bucket of clean water.
3. Activate the hose handle until clean water comes
out of the nozzle (approx. 30 seconds)