6.6.1.
Supply of detergent
Satellite without User Pack system.
See drawing no 110003498
• Place the can with detergent in the can holder
• Check the suction filter for impurities.
• Put the suction hose into the can below product
level and avoid suction of air.
• After pre-rinsing, check again that the hose is suf-
ficiently below product level and avoid suction of
air during foam or spray operation.
• After use of and when changing product as well as
after use of the unit, remove the hose from the can
and rinse the product inlet line and injector with
clean water.
Satellite with User Pack system
See drawing no 110003485.
• Place the specially designed User Pack in the
automatic holder.
• If changing to a different product when ending the
cleaning process, rinse the product inlet line with
clean water as follows:
Replace the User Pack containing product by one
with clean water; place the foam nozzle and open the
spray gun/outlet valve. The product inlet line is now
rinsed with clean water before use of another product.
6.7. Hose Connection
• The special hose fitted with spray gun/outlet valve
is connected to the outlet quick coupling of the unit
(layout drawing).
• Maximum hose length: 30 m.
• It is recommended only to use Nilfisk FOOD
hoses, which have been tested for resistance.
110003498
6.8. Installation
There should be a shut off at each pre-diluted inlet.
The prediluted supply system must have a pressure
relief valve and non return valve installed.
110008148
Take care to test pressure relief valve before mount-
ing. Take care to perform service and maintenance of
the pressure relief valves according to the supllier´s
instructions.
The piping used for the prediluted detergent should
have a pressure rating of min. 37,5 bar in case of
defects.
The material used for piping must be in compliance
with the prediluted detergent. A deteriorated supply
pipe can leak and be a risk for the personnel.
Use only original spare parts.
>20 sec.
110005307
187