Air Connection; Supply Of Detergent; Hose Connection - Ecolab Hybrid Foamatic MA2CM Mode D'emploi

• The pressure loss in the supply line
must be held as low as possible by:
- avoiding long supply pipes
- mounting low pressure resistance
ball valves and
- avoiding fittings with high pressure
loss.
• When installing the piping, take care
to avoid air traps.
• All pipe connection to the unit must be
clamp connections ensuring simple
maintenance and dismantling of the
station.
Allowed temperature of supply water: 70°C
Allowed pressure of supply water: 2-8 bar
For an optimum functioning of the injec-
tor system, we recommend installing a
filter on the inlet to avoid impurities.
Water inlet

6.7. Air connection

Before the unit is connected to the air
supply, the pipe system must be care-
fully rinsed in order to remove coarse
impurities.
• The unit requires an air supply boosting
- an inlet pressure of minimum 6 bar
- a minimum capacity of 200 l/min.
• The air supply pipe is connected directly with
a quick fitting for easy dismantling. In all units
an inlet valve with 1/4" thread is fitted (layout
drawings).
110005307
Mainstation with user pack system
See drawing no 110005307.
Replace the User Pack containing product by one
with clean water; place the foam nozzle and open
the spray gun/outlet valve. The product inlet line is
now rinsed with clean water before use of another
product.
110005283

6.8. Supply of detergent

A
Mainstation without user pack system.
See drawing no 110003498

6.9. Hose connection

>20 sec.
• Place the specially designed user pack in the
automatic holder.
• If changing to a different product when ending
the cleaning process, rinse the product inlet
line with clean water as follows:
• Place the can with detergent in the can holder
• Check the suction filter for impurities.
• Put the suction hose into the can below product
level and avoid suction of air.
• After pre-rinsing, check again that the hose is
sufficiently below product level and avoid suc-
tion of air during foam or spray operation.
• After use of and when changing product as well
as after use of the unit, remove the hose from
the can and rinse the product inlet line and
injector with clean water.
• The special hose fitted with spray gun/outlet
valve is connected to the outlet quick coupling
of the unit (layout drawing).
• Maximum hose length: 30 m.
• It is recommended only to use Nilfisk FOOD
hoses, which have been tested for resistance.
110003498
110005290
17