Power Supply; Mounting; Operation - Ecolab MSM10 Mode D'emploi

6. Power supply

A single pole main switch should
be installed close to the MSM unit
to make servicing the unit easyer.

7. Mounting

It is recommended to mount the
MSM in an appropriate height,
however, max. 1,2 m / 4' 3" above
the floor on a moisture repellent
wall construction. The unit must be
placed so that the water inlet hose
can reach the connecting point.
Secure the MSM, Hoseholder and
Can holder on the wall with the
enclosed screws and rawlplugs.
The inclosed drilling template can
be used for marking-out when
mounting the unit.
Note: Can holder should be placed
so that the can is under the level of
the unit.

8. Operation

Before putting the MSM into opera-
tion, please follow the instructions
below:
Connect the unit to the water sup-
ply using the enclosed inlet hose.
Connect the outlet hose and the
handle.
The correct chemical limiting
nozzle is selected from the below
table or from instructions given by
Ecolab personal and connected
to the hose coup ling nipple of the
chemical non-return valve.
The chemical hose is connected
to the hose coupling nipple of the
chemical non-return valve.
The unit is now ready for use.
4
Mounting of chemical limiting nozzle
Fig. 2
110000895