Télécharger Imprimer la page

Yamaha MT09 2017 Instructions De Montage page 5

Publicité

Les langues disponibles
  • FR

Les langues disponibles

7. Align the indicator brackets with your number plate and tighten the screws fully (P1).
8. Install the reflector at the mounting bracket. Install the bracket for the reflector with the 5 mm stop
nuts and the 5 mm washers at the plate holder no. 4630 and tighten the nuts and screws. Install the
number plate light on the plate holder using the two cross head screws (P3+P4).
C) Installation of the MRA plate holder on the motorcycle
9. Install the MRA plate holder with the 4 provided 6 x 12 mm Allen screws at the vehicle and tighten
the screws.
10. Adjust the angle of inclination for the plate holder. ! The adjustment angle may not exceed 30° to
the vertical.
11. Tighten the M5 and M4 Allen screws.
12. Install the indicators at the plate holder. Optionally, the accessory indicators can now be installed
(not included in the scope of delivery).
13. Now connect the electrical cables for the plate light and indicators.
!
All electrical wiring must be properly insulated and fixed with cable ties such that it
cannot be squashed and no short circuits can occur.
14. Install the provided aluminium spacer instead of the original plate holder into the bracket, install the
original washer and axis nut and check that the rear wheel is positioned in the centre of the bracket.
Tighten the axis nut with 150NM. (P5)
15. You can now reattach the battery and then check the functioning of the lights.
16. The disassembled components can now be reattached in reverse order.
17.
Finally, reinstall the license plate, the seat cushion and the seat.
Important note: If you have a EURO 4 model, you will need to replace any reflectors originally mounted
onto the old registration plate holder when installing your new registration plate holder. You may mount
the replacements on another part of your bike, such as on the forks.
Check that the screws are still tight and tighten them again if needed after installation, and repeat at
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
intervals after that.
5

Publicité

loading