Safety Information - Wetrok Speedmatic Tornado P Mode D'emploi

Routine control and maintenance
Operations and safety checks
1. The machine must be inspected by a specialist technician who checks its safety or for any damage or defects in the following cases:
– before it is put into operatio;
– after modifications or repairs;
– at regular intervals, as indicated in the „Routine maintenance and checks" table.
2. Every six months check that the safety devices are in good working conditions; the inspection must be made by authorized specialist staff. To ensure that the
safety devices are properly operating , the machine must be overhauled by specialist staff or skilled workshop every 5 years.
3. The person in responsable of the machine must make an annual check of its condition. During this checking, he must decide whether the machine still complies
with the technical safety regulations. After checking it has to apply on the machine a label of checking made.
Periodic maintenance and checks (electric sweeper)
1 Check level of electrolyte in batteries
2 Check carbon brushes of drive motor
3 Check carbon brushes of brush and suction fan motors
4 Check that the main brush is not entangled with string, wire, etc.
5 Check and clean panel filter
6 Replace panel filter
7 Check traces of side brush(es)
8 Check belt tension
Periodic maintenance and checks (petrol sweeper)
1 Check the engine oil level
2 Check the engine air filter
3 Cleaning of the motor air filter
4 Change the engine oil
5 Check the tension of the belts
6 Check the battery electrolyte level
7 Check the trace of the main and side brushes
8 Check that the main brush does not have string, wire, etc. entangled up in it.
9 Check the dust filters
10 Replace the dust filters
11 Staubfilter kontrollieren
12 Staubfilter ersetzen

SAFETY INFORMATION

1) Cleaning:
When cleaning and washing the machine, take care when using aggressive detergents, acids, etc.
Follow the instructions provided by the detergent producer, and wear protective clothing if appropriate (e.g. overalls, gloves, goggles, etc. – see EEC directives on
this subject).
2) Explosive atmosphere:
The machine is not constructed to work in environments where there is a risk that there might be explosive gases, dusts or vapours, and so its use in an explosive
atmosphere is FORBIDDEN.
3) Disposal of harmful substances:
Comply with the laws in force on waste disposal and treatment when disposing of the material collected, the machine filters and spend material such as batteries,
motor oil, etc.
8
3
3
8
3
3
3
38
Every hours
40 150 500
3
3
3
3
3
Every hours
40 150 500
3
3
3
3
3
3
3
1500
3
1500
3
3