Starting Work; Starting The Engine (Petrol Sweeper) - Wetrok Speedmatic Tornado P Mode D'emploi

Starting work

FIG 5
3
5
Electric sweeper
Starting the engine
FIG 6
Petrol sweeper
– Press on pedal 9, fig. 3 and release handle 2 (fig. 6) from its notch to disengage the brake.
(Petrol version)
– Press on the right side (pos. A) of the drive pedal 7, fig. 3 to move forward;
– Press on the left side of the same pedal to move backwards.
(Electric version)
– Push on the switch 8 (Fig. 3) to select the direction of the sweeper. Act on pedal 7 for the transfer;
– Direction I: FORWARD, Direction II: BACK (reverse).
Switching off the engine
– Turn the ignition key to position 0;
– Apply the parking brake lock (see "parking brake" chapter);
– Lift the main and side brushes off the floor.
8
2
6
Petrol sweeper
1. Check that the brushes are raised off the floor
(levers 2, 6).
2. Release the brake pedal 9.
3. Insert the key 3 in the key switch and turn it
clockwise.
(for the petrol sweeper, see "starting the engine")
4. Switch on the suction fan, main brush, and side
brush motors, pushing the switch 5 (electric
sweeper).
5. Lower the main and side brushes by means of
levers 2 and 6.
6. Select the transfer direction of the machine by the
switch 8 (electric version).
7. Press gradually on pedal 7.
!
1. Pull the starter 1, fig.5, to pos.B. Also apply the
STARTER to start the engine when it is hot!
2. Turn the starter key 3 (fig. 6) to position 2 and hold
it until the engine starts.
3. Leave the key return to position 1 as soon as the
engine starts.
4. Gradually return the choke to OFF (position A) as
the engine warms up.
!
27
WARNING! Make sure that the drive
pedal 7, (fig. 3) is in neutral.
WARNING! Do not use the electric start
for longer than 5 seconds each time. If
the engine does not start, release the
switch and wait 10 seconds before trying
the starter again.