Programming With The Ir Remote Control; Procedure Plan - MC Crypt 59 09 96 Notice D'emploi

8. Programming with the IR remote control

Of course, you can also program the LED light writing without a computer using the IR remote control.
However, we recommend using the supplied software and the USB connection cable (or the RS232
connection cable) to generate texts and effects and transferring them to the LED light writing.
This not only saves time, but you can also save, load and edit the generated texts/effects on the computer
and try out all possibilities of the LED light writing.
a) Procedure plan (see graphic on the next side)
START
Input message
Select page edit
Change page
Select leading and display effect
Select closing effect
Select display time
Select moving speed
Select schedule display
Select year, month....
Input display pages
Clear all
Set ID
Set/Select brightness
Set/Select clock year
Set/Select clock month
Set/Select clock date
Set/Select clock hour
Set/Select clock minute
Input page ABC...Z
Start of programming
message input
Call up of the page selection mode
Select page
Start effect (e.g. insert text) or select display effect (e.g. blinking)
Selection of closing effects (e.g. fade out text)
Selection of the time at which the text is displayed
Selection of the runtime for the effect
Selection of a certain time at which the message is to appear
Selection of the month, year, etc.
Selection of the pages to be displayed
Delete all data
Setting the ID of the LED running light (if several running lights are controlled)
Setting the brightness
Setting the year
Setting the month
Setting the date
Setting the hours
Setting the minutes
Selection of which of the programmed pages (A....Z) are to be displayed in
which sequence (z.B. ABC, LBQV...)
33