Viscount
Prestige 100
2.4 PEDAL BOARD CONTROLS
1
1. Coupler pistons: these pistons activate the organ couplings described in par. 2.1 and/or 2.3.
2. General memory pistons: these pistons can be used to recall the organ general memories.
There are also the [MEM+] and [MEM-] pistons to select the memories in ascending and
descending order.
3. [CRESCENDO] pedal: this pedal can be used to select the Crescendo steps which activate a
preset series of stops. The step currently selected is displayed by the [CRESCENDO] LED bar
on the centre panel (see also point 11 of par. 2.2).
Each Crescendo step is programmable. To do this, use the [CRESCENDO] pedal to select the
step required, switch on the voices and couplers needed, press button [S] and, keeping it pressed
down, then press the general memories [HR] button.
4. [MAN. I] pedal: expression pedal used to control the volume of the first manual.
5. [MAN. III] pedal: this expression pedal is used to control the volume of the third manual.
6. [MIDI SUSTAIN] piston: Sustain piston of the Orchestra voices and by which CC64 is sent
to the [MIDI OUT].
7. [MIDI REVERSIBLE] piston: cancels the current MIDI To settings to allow a new set up.
By deactivating MIDI Reversible, the MIDI To settings will revert to how they were before the
piston was turned on.
8. [TUTTI] piston: the piston used to activate the Tutti. For a more detailed description, refer to
point 11 of par. 2.3.
- Quick Guide
3
4
5
2
36
6
7
8