Making Hot Water - Ascaso Dream Manuel De L'utilisateur

Masquer les pouces Voir aussi pour Dream:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

ascaso
Possible problems.
The cream may be too thin and lack
consistency.
1. One possible reason is that the
2. The milk has been overheated (the
5.
3. Put a cup below the steam nozzle
4. Turn on the hot water/steam knob
6.
model
The PID models have a control
system consisting of a screen
two control buttons
the following functions:
1. Coffee temperature, shown on
2. Temperature units, in °C or F.
3. Pre-infusion, selecting a pump
4. Timer, showing the time taken
28
manual DREAM PID_ES_EN_DE_NL_FR.indd 28
manual DREAM PID_ES_EN_DE_NL_FR.indd 28
milk has already been heated.
steam nozzle has been placed
too deeply in the jug and the milk
has been heated without allowing
the air to circulate on the surface)
before the required texture has
been attained. Step 1 (texturing)
has not been performed
properly and the air has not
been allowed to work the milk.

Making hot water

5
.
and press button (3-I) (the pilot
4
light will come on
. Carry out
23
the reverse operation to obtain the
required water.
Functions of the PID
to control
22 23
the screen. To change it, press
button
, the screen will display
22
the message PrG, indicating that
it is in temperature programming
mode. Press button
to reduce
22
the temperature, press
23
increase it. If three seconds pass
without a button being pressed, the
system will return to its initial state.
activation time during the process,
from 0 (off) to 5 seconds.
to make a coffee. This function
can be turned on or off in the
programming menu. If on,
the screen
taken to make a coffee, not the
temperature.
5. In stand-by mode, selecting an
activation period from 0 (off),
0.5/1/2 hours.
6. Correction parameter between
water temperature and
measurement in the machine. This
enables the water temperature to
be adjusted according to room
temperature.
Enter the programming menu to
change the values of parameters 2 to
7. The process is as follows:
7. With the machine on, press and
hold button
for three seconds. The screen
21
will show the words SET UP
alternately, indicating that the
programming menu has been
accessed.
8. Press button
through the different modifiable
parameters. Once the required
parameter is reached, press
button
21
and
9. To change the value of the
selected parameter, press buttons
and
22
the values, respectively.
10. After three seconds without
pressing a button, the system
saves the data and returns to its
initial setting.
to
NB! The PID system can be reset
in the following way: With the machine
on, press the button
seconds. The screen
text PrS, indicating that the factory
settings have been reset.
21
shows the time
while pressing
23
22
to scroll
22
to change its values.
23
to reduce or increase
23
for three
23
will show the
21
09/12/2019 11:22:36
09/12/2019 11:22:36

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Dream pid

Table des Matières