Stand-By Mode; Maintenance And Cleaning - Ascaso Dream Manuel De L'utilisateur

The table of parameters and available values is given below:
7.
An energy saving mode is included
in the PID models, which turns the
machine off after two hours without
activating a function.
When stand-by mode is on, only pilot
light
turned off.
To turn the machine on again, just
press any of the buttons for the
machine to go back to its initial status,
as if turned on for the first time.
on and off using the PID system
controls
of this manual.
manual DREAM PID_ES_EN_DE_NL_FR.indd 29 manual DREAM PID_ES_EN_DE_NL_FR.indd 29
Param. Value - Description
C Degrees Celsius
Ud
F Degrees Fahrenheit
0 Pre-infusion off
Pr
1 Pre-infusion 1 s
2 Pre-infusion de 2 s
3 Pre-infusion de 3 s
4 Pre-infusion de 4 s
5 Pre-infusion de 5 s
ON Timer on
Cr
OFF Timer off
OFF Stand-by mode OFF
OFF
0.5 Stand-by mode ON, starting in 0.5 h
001 Stand-by mode ON, starting in 1 h
002 Stand-by mode ON, starting in 2 h
X X indicates the offset between the set tempe-
U
rature and the one shown on the display

Stand-by mode

remains lit while all others are
6
NB! The function can be turned
and . See section 6
21 22 23
ascaso
Default value
C
0
OFF
OFF
0
8.

Maintenance and cleaning

Cleaning and preventive care of the
machine's internal system is vital if an
espresso of optimum quality is to be
obtained.
General warning! Cleaning and
maintenance should be done when
the machine is cool and disconnected
from the power source. Do not
place the machine under water. Not
dishwasher safe.
29
09/12/2019 11:22:36 09/12/2019 11:22:36