GETINGE Arjohuntleigh Enterprise E8000X Notice D'utilisation page 32

These buttons raise and lower the thigh section.
Thigh section
When the thigh section is first raised from the flat position, the
calf section will be in the Fowler position (angled downwards).
To change the calf section to the vascular (horizontal) position,
refer to the section Adjusting the calf position on page 37.
These buttons raise and lower the backrest.
Backrest angle
The Bio-Contour up button simultaneously raises the backrest
Bio-Contour
and thigh sections to provide upright patient profiling; the
raised thigh section prevents the patient sliding down the bed.
The Bio-Contour down button returns the mattress platform to
a flat position.
These buttons raise and lower the mattress platform.
Mattress
platform height
When the mattress platform is lowered to 38cm* above the
floor, it will pause then continue to lower until it reaches its
minimum height.
(* 40cm on beds with 150mm castors.)
WARNING
At minimum height, clearance underneath the bed is reduced. Keep
your feet away from the areas below the side rails and take extra
care when using patient hoists or similar equipment.
32