Telefunken TX 100 Série Mode D'emploi page 74

- If you are connected to a PABX, check whether you need to dial an access code.
Handset does not ring
- The ringer volume may be switched off..
- Check that the mains power is correctly connected.
- Make sure the handset is registered to the base.
No display
- The battery pack may be flat, dead or incorrectly inserted.
- Recharge or replace the battery pack
Battery icon does not appear to be filling
- Try cleaning the charging contacts.
- Check that the mains power is correctly connected.
- If the above measures do not correct the problem, replace the battery pack.
You hear the busy tone when you press HOME
- Make sure the handset is in range of the base.
- Another handset registered to your TELEFUNKEN TX 1** base may be on the line.
Answering machine does not record any messages
- Make sure the answering machine is switched on.
- The memory may be full, please delete some old messages to free up space.
- Make sure answering machine is set to ANSWER & RECORD mode.
Answering machine messages have the wrong date and time
- Have you manually set the date and time?
Cannot access your messages from another phone
- Have you changed the remote access security PIN code?. Always keep a note of the new PIN
code in a safe place.
- Has remote access been disabled?
- Make sure you are calling from a touch-tone telephone. When dialing a number, there should be
tones. If there are clicks, then it is not a touch-tone telephone and cannot activate the answering
machine.
- The answering machine might not detect the remote access code when your announcement is
playing. Wait until the announcement is over before entering the code.
- There might be interference on the telephone line you are using. Press the dial pad keys firmly
when dialing.
No Caller number/name displayed
- Have you subscribed to Caller ID service?
- The caller may have blocked their number.
- An exact name/number match was not found in your phonebook. Check that you have stored the
complete number including area code.
- The caller might not be calling from an area which supports Caller ID.
Both you and the caller's telephone companies must use equipment compatible with the Caller ID
-
service.
- The Caller ID information shows after the first or second ring.
Base unit does not ring, but the lights are on
- Have you connected the telephone line correctly?
- Is the base ringer set to off?
- You may have a faulty line or socket. Try using another socket.
Buzzing noise on my phone or on other electrical equipment nearby
TX Bluetooth Guide 74