Telefunken TX 100 Série Mode D'emploi page 53

connected devices are temporarily disconnected until the procedure is complete. It may take up to
two minutes to reconnect.
Review the active devices list
1. In standby mode, Press MENU/OK and choose Bluetooth
2. Select Active devices,
3. You can review the Active devices with UP/DOWN
Connect/disconnect an active device
While in the active devices menu, you may connect or disconnect your active device.
1. In standby mode, Press MENU/OK and choose Bluetooth.
2. Select Active devices.
3. Select the device you wish to connect/disconnect
4. Press MENU/OK to select Connect or Disconnect
5. Press MENU/OK to confirm. The handset displays Device connected/Device
disconnected.
Replace an active device
You can replace an active device with a device on the paired devices list even if you already have
two devices on the active devices list.
1. In standby mode, Press MENU/OK and choose Bluetooth.
2. Select Paired devices.
3. Select a device.
4. Select Connect.
5. Confirm by MENU/OK. The handset display Maximum of 2 devices can be connected
and then Replace an existing active device with mobile? Press Menu/OK.
6. Select the device to be replaced, then press MENU/OK.
7. The handset displays Device removed from active devices list and then Connecting
Mobile Phone A to the base...
8. Depending on your MOBILE phone settings, you may need to press a key on your MOBILE
phone to confirm the connection. When you successfully replace and connect an active
device with a paired device, the handset displays Device connected.
Add an active device
You can have a maximum of two devices on the active devices list.
1. In standby mode, Press MENU/OK then choose Bluetooth.
2. Select Active devices.
3. Select Empty position
4. Select Add.
5. Select a device from the paired devices list.
6. Press MENU/OK.
7. The handset displays Device added to active list and then Connecting Mobile Phone B
to the base... If there are no paired devices to add, the handset displays All paired
devices are devices already connected.
8. Depending on your mobile phone settings, you may need to press a key on your mobile
phone to confirm the connection. When you successfully add and connect an active device, the
handset displays Device connected.
Remove an active device
You can remove an active device from the active devices list.
1. In standby mode, press MENU/OK and choose Bluetooth.
2. Select Active devices,
3. Select the desired device.
4. Select Remove active.
5. Press MENU/OK.
TX Bluetooth Guide 53