How To Operate The Freezer; Thermostat Setting; Display Panel - BORETTI BV-83 Notice D'emploi

PART 2. HOW TO OPERATE THE FREEZER

Thermostat Setting

The freezer thermostat automatically regulates the inside temperature of the compartments. By rotating the knob from
position 1 to 5, colder temperatures can be obtained. "0" position shows thermostat is closed and no cooling will be
available.
Freezer Thermostat Setting;
0 : The appliance is switched off.
1 - 2 : For short-term storage of food in the freezer compartment, you can set the knob between minimum and
medium position.
3 - 4 : For long-term storage of food in the freezer compartment, you can set knob to medium position.
5 : For freezing the fresh food. The appliance will run for colder temperatures.
SF : The compressor will start to run continuously with maximum performance. The freezer temperature will
decrease and the appliance will switch to the lowest temperature. Place the food to be frozen quickly inside
the freezer, preferably in the middle drawers. Once the food is frozen, you must set the thermostat knob to
desired position.
Note 1; Observe that the orange lamp will light when the compressor runs. So when SF is active , the compressor will
run continuously and the lamp will light continuously.
Note 2; The ambient temperature, temperature of the freshly stored food and how often the door is opened, affects
the temperature in the refrigerator and freezer compartments. If required, change the temperature setting.

Display Panel

Compressor light : Lights orange, when the compressor runs. In SF mode , it will light continuously.
Power light: Lights green automatically, when the appliance is connected to the power supply.
$ODUP OLJKW Lights red, when the temperature rises to a critical point in side the freeze.
Power Light
Compressor
Light
Alarm Light