Safety Switch Off Function; Suggestions And Recommendations; Cleaning And Maintenance - ROSIERES RIS3BC Instructions Pour L'installation

After the desired "Flexi Zone" is
selected, you can assign the power
by touching any of the "sliders" cursors
(2) of one of the linked zone. The
power level and its variations are
displayed simultaneously on the power
indicators (3) of both zones.
To disable this feature, you should
touch the sensor
Also, when the function is disabled,
the levels of powers and functions
assigned to the related zones are
cleared.

Safety switch off function

If due to an error one or several
heating zones do not switch off, the
appliance will be automatically discon-
nected after a set amount of time (see
table 1).
Table 1
Selected MAXIMUN
power OPERATING TIME
level (in hours)
1
2
3
4
5
6
7
8
9
10 or 5 minutes,
P read justs to level 9
(depending on model)
* Depends on model
When the "safety switch off" function
has been triggered, a 0is displayed if
the glass surface temperature is not
dangerous for the user or an H if there
is a burn risk.
Fig. 3
Keep the control panel of the
heating areas clean and dry at all
times.
In the event of operating pro-
blems or incidents not mentioned
in this manual, disconnect the
appliance and contact the technical
(14) again.
service.
Suggestions and
recommendations
* Use pots or pans with thick, comple-
tely flat bottoms.
* Pots/pans with a smaller diameter
than the shown heating area are
not recommended.
* Do not slide pots and pans over the
glass because they could scratch it.
* Although the glass can take knocks
from large pots and pans without
sharp edges, try not to knock it.
* To avoid damaging the ceramic
glass surface, do not drag pots
and pans over the glass and keep
0
the undersides of them clean and
8
in good condition.
* Recommended diameters of the pot
8
bottoms
5
4
4
3
2
2
Table 2
Recommended
Zone (mm.) minimum diameter
(mm.)
Ø145 Ø100
Ø180 Ø120
Ø210 Ø130
Ø260 Ø140
Ø280 Ø150
Ø280DZ Ø110/200
Ø300DZ Ø120/210
Flex 235x180 Ø120
Flex 270x180 Ø140
Try not to spill sugar or pro-
ducts containing sugar on the glass
as while the surface is hot these
could damage it.

Cleaning and maintenance

To keep the appliance in good
condition, clean it using suitable
products and implements once it has
cooled down. This will make the job
easier and avoid the build-up of dirt.
Never use harsh cleaning products or
tools that could scratch the surface, or
steam-operated equipment.
Light dirt not stuck to the surface can
be cleaned using a damp cloth and a
gentle detergent or warm soapy water.
However, for deeper stains or grease
use a special cleaner for ceramic hot
plates and follow the instructions on
the bottle. Dirt that is firmly stuck due
to being burned repeatedly can be
removed using a scraper with a blade.
Slight tinges of colour are caused by
pots and pans with dry grease residue
underneath or due to grease between
the glass and the pot during cooking.
EN
11