Pause Function; Recall Function; Booster Function - ROSIERES RDVE342MPN Manuel D'utilisation

Pause Function

When at least one cooking zone is in operation, the heating elements may be switched off by actuating the
special key "pause" for >= 1s. Already programmed times (also egg timer) are stopped and do not continue
during the pause. Automatic heat-up and booster are also switched off on all cooking zones during activation,
the residual heat calculation and operating time limitation continue and are not stopped. The pause condition
may last for max. 10 minutes. If the status is not terminated within this time, the control switches off. The cooking
zone may be switched at any time with the on/off key – a possibly activated pause mode is then terminated.
In order to terminate the pause mode and put into operation again the cooking zones, the special function
key and any other key (not the same again) has to be actuated within 10 seconds.

Recall Function

By using of the recall function the settings may be recovered quickly, when the control had been switched off
with the main switch by mistake. After switching off the power key the operator has 6s to switch on again the
control and another 6s to actuate the pause key. The pause mode is not possible within the first 6s after
switching on. The execution of the function is only possible, if at least one cooking zone was active (cooking
stage > 0), independent from the key-lock status and is confirmed with an acoustic key signal.
The following is re-established:
-
Cooking stages of all cooking zones
-
Minutes and seconds of programmed cooking zone-related timers
-
Switching condition of the outer circuits (is guaranteed by outer-circuit memo function)
-
Heat up function and booster

Booster function

After selection of a respective cooking zone, the boost function can be selected directly via the boost function
key. If the desired cooking zone has the capacity to receive this power, the display shows a "P" symbol.
In case the power is not permitted the cooking stage display flashes for 3 sec on the cooking zone which needs
to be reduced and which requires automatic adjustment. The boosting time is limited to 10 min. After the booster
is switched off automatically, the cooking zone continues operation on nominal power. The booster can be
reactivated provided that the temperature sensors in the electronics and in the coils have the capacity.
In case that the pan is removed from the cooking zone during boosting, the boosting function remains active and
boosting time continues. If the booster temperature limit of the electronics or the coil of a boosted cooking zone
is exceeded, the booster is cut off automatically and reset to nominal power.
Fan control (Integrated cooling of the generator)
The cooling is integrated within the plastic housing of the Inductor heat element. The operation of the fan is
controlled by the temperature which is measured at the heat sink. Then fan switches on, when a certain
temperature is reached and switches to a higher speed when the second temperature limit is reached.
Start lower speed 45° C
Start higher speed 55° C
Generator
Pot with bottom with ferromagnetic material
Magnetic field
Glass-ceramic surface
Coil to spiral of Archimedes