Progress PBP5360 Notice D'utilisation page 36

36 progress
To stop the Pyrolysis before it is com-
pleted, press
Setting the end time for the Pyrolysis
You can use the End
lay the start of the procedure.
1. Start the Pyrolysis procedure.
2. Press
again and again until the
symbol
shows the time for the end of the
Pyrolysis.
Removing the shelf supports
1
Installing the shelf supports
Install the shelf supports in the opposite se-
quence.
The rounded ends of the shelf supports
must point to the front.
Oven lamp
Warning! Be careful when you change
the oven lamp. There is a risk of
electrical shock.
Before you change the oven lamp:
• Deactivate the oven.
• Remove the fuses in the fuse box or de-
activate the circuit breaker.
Put a cloth on the bottom of the oven
to prevent damage to the oven light
and glass cover.
.
function to de-
flashes. The display
2
3. Press + or - to adjust the time for
the end of the Pyrolysis.
Shelf supports
You can remove the shelf supports to clean
the side walls.
1. Pull the front of the shelf support away
from the side wall.
2. Pull the rear end of the shelf support
away from the side wall and remove it.
1. Turn the glass cover counterclockwise
to remove it.
2. Clean the glass cover.
3. Replace the oven light bulb with an ap-
plicable 300 °C heat-resistant oven
light bulb.
Use the same oven lamp type.
4. Install the glass cover.
Cleaning the oven door
The oven door has three panels of glass.
You can remove the oven door and the in-
ternal glass panels to clean them.
The oven door can close if you try to
remove the glass panels before you re-
move the oven door.