Ice Maker Operation; Care Recommendations; Condenser (Behind Grille) - Sub-Zero Icbpro3650 Guide D'utilisation Et D'entretien

OP ER AT I O N

Ice Maker Operation

To initiate ice production, touch on the freezer external
touch display. will be visible in the display. After initial
start-up, discard the first few batches of ice. The ice may
contain impurities from new plumbing connections.
Max ice increases ice production up to 30% for a 24-hour
period. Touch to activate max ice. will be visible in
the display.
If ice is not used regularly, it may fuse together. To avoid,
discard the ice and allow the ice maker to replenish.
Sabbath
This appliance is certified by Star-K to meet strict religious
regulations in conjunction with specific instructions found
on www.star-k.org.
C A RE RE CO MME N DATIO N S
Cleaning
INT E RIO R C L E AN IN G
To clean interior surfaces and all removable parts, wash with
a mild solution of soap, water, and baking soda. Rinse and
dry thoroughly. Avoid getting water on the lights.
CAUTION
Do not use vinegar, rubbing alcohol, or other alcohol-
based cleaners on any interior surface.
S TA INL E SS ST E E L E X TE R IO R
Use a nonabrasive stainless steel cleaner and apply with
a soft lint-free cloth. To bring out the natural luster, lightly
wipe the surface with a water-dampened microfiber cloth
followed by a dry polishing chamois. Always follow the grain
of stainless steel.
CO ND EN SE R CL EA N IN G
CAUTION
Before cleaning the condenser, turn power off to the unit.
Wear gloves to avoid injury from sharp condenser fins.
The condenser is located behind the grille. To access, rotate
the bottom of the grille upward. Use a soft bristle brush
and vacuum to remove dust and lint from the condenser.
Clean the condenser every three to six months. Refer to the
illustration below.
IMPORTANT NOTE: To avoid damaging the condenser fins,
vacuum in the direction of the fins.
CAUTION
Failure to clean the condenser could result in tempera-
ture loss, mechanical failure, or damage.
VA C ATION S
For extended vacations, turn the unit off. Empty the unit and
block doors open to let fresh air in and keep the interior dry.
The water filter should be replaced before start up.
CONDENSER
Condenser location
subzero.com
|
7