Operation; Pull-Out Shelf; Refrigerator Storage Drawer; Freezer Storage Drawer - Sub-Zero Icbpro3650 Guide D'utilisation Et D'entretien

ST OR AG E
Refrigerator Storage
P ULL-O U T SH E L F
The bottom shelf pulls out for easy access to condiments
and other items commonly stored on door shelves. Adjust-
able rails keep items snugly in place. To adjust, pull the rail
up and rotate. Refer to the illustration below.
CRISP ER L ID
To remove the crisper lid assembly, pull the upper refrig-
erator drawer all the way out, raise the front edge of the
crisper lid up, and pull out from the back. Refer to the
illustration below.
DRAW ER D I V ID ER S
Long dividers run the full depth of the drawer, with shorter
dividers that connect to the long dividers to compartmen-
talize the drawer.
To remove the short dividers, lift up and out. The long
dividers cannot be removed.

Pull-out shelf

Crisper lid (1219 mm model
shown)
|
6 English
Freezer Storage
S TA INLES S S TEEL S HELV ES
For 1219 mm models, to remove or adjust a shelf, tilt up,
then lift up and out. To install, insert the shelf in the tracks
along the back wall, then lower the front until it locks into
position.
ICE CONTA INE R
To remove the ice container, pull the drawer out to full-
extension, then lift the container up and out.
Storage Drawers
Refrigerator and freezer storage drawers are removable
for cleaning. An automatic stop is built in to prevent the
drawers from coming all the way out unintentionally.
To remove, pull the drawer out to full-extension, lift up
evenly on both sides of the drawer front, and pull out. Refer
to the illustration below.
Storage drawer removal
O P E RAT IO N
Air Purification System
The advanced air purification system reduces bacteria,
odors, and ethylene gas, which causes premature ripening
in fruits and vegetables. The air purification cartridge has
been factory installed and is located inside the refrigerator
on the back wall.
To initiate air purification, touch , then touch
The cartridge will last approximately one year. "Change Air
Purifier" will appear on the display when the cartridge needs
to be replaced. Touch "Snooze" to delay the reminder for
24 hours or until cartridge can be replaced. Touch "Refresh"
to reset the life indicator to 100% once the cartridge is
replaced.
A IR P U R IFICATION C A RTR IDGE R EP L A C EME N T
To access the air purification cartridge, grasp the outside
1
cover from the bottom and rotate upward. Refer to the
illustration below.
Grasp the black cover from the top and rotate down-
2
.
ward. The cartridge will pop out and can be removed.
Remove the new cartridge from packaging and insert
3
with the connector pointing downward.
Once in position, close the black cover. Then rotate the
4
outside cover downward until it closes against the back
wall.
Once the cartridge has been replaced, follow the instruc-
5
tions on the display. The cartridge life cycle will reset for
approximately one year.
Air purification cartridge